DB 2.0 Manual Center Stand - 2009 and Up Touring Models

Expected 1-2 Week Lead Time for Manufacturing Prior to Shipping

Please measure the height from the bottom of your frame to the ground when the motorcycle is fully lowered. Measure at the flatter point of the rear lower frame juts before the frame begins to curve up (see photo). It is imperative that you measure correctly or your bike is at risk of falling over after the stand is installed. The measurement task requires two people. One person straddles the bike, while the second person measures the ground clearance. It is imperative that (1) the bike is measured on flat ground with the frame straight up and down; (2) the right and left frame rails are level to the ground; and (3) the bike is lowered into the lowest position. When the bike is level to the ground, with a second person holding the bike up, measure the bike in the lowest position. You shall do so by measuring the lowest point of the frame to the ground at the flattest point of the rear lower frame just before the frame begins to curve up.
Please note this measurement in the "SPECIAL INSTRUCTIONS FOR SELLER" field on your Shopping Cart page before clicking the "CHECK OUT" option. This information is required to ensure you are given the correct center stand size.

Please also input a phone number in the "SPECIAL INSTRUCTIONS FOR SELLER" field on your Shopping Cart page before clicking the "CHECK OUT" option. This information is required by our shipper.

Dirtbags California partners with American Suspension to bring you the Dirtbags 2009 And Up Manual Center Stand for Touring Models